SMOOTH JOINTLESS FLOORING COATINGS – 5FI series

„Smooth” flooring coatings are a special group of materials, which after application create a coherent and even floor’s usable area. These types of materials’ parameters are practically permanent within a very wide range of temperatures as well as exposed to different types of external hazards. The application possibilities of these plastics are enormous. To begin with simple social-service back-up facilities and protective coatings in multi-storeyed garages, up to production plants and warehouses designed for maximum bearing capacity and resistant to all types of hazards, to finish with coatings designed for explosive conditions rooms.

Below you will find basic types of flooring plastics from the PLASTIPOX 5FI series:

  • PLASTIPOX 5FI self levelling plastic for thick layer floors.
  • PLASTIPOX 5FI-m plastic for thin layer painted floors.
  • PLASTIPOX 5FI-P plastic for thick layer trowel spread floors.
  • PLASTIPOX 5FI-s modification of PLASTIPOX 5FI-P plastic (same technical and operational parameters but increased raw material purity) – for thick layer floors in the highest health standard environments (hospital, day nursery, sanatorium, etc.).

The available colours for each of the above mentioned types are practically unlimited – after prior consultation with PPME AMEPOX. The 5FI series materials create a coherent, joint-less surface of high resistance to different typical chemical substances and exploitation factors. These types of floors are easy to be kept clean and are very convenient for daily maintenance.

Prior to installation of the 5FI-type smooth, joint-less floor, one of priming mixes has to be applied on the concrete’s surface

rys1

For basic technical data on „smooth” flooring plastics, see the table below:

PARAMETERS
PLASTIPOX 5 FI
PLASTIPOX 5FI-P (s)
PLASTIPOX 5FI-m
Viscosity [Pa s]
2.2 – 2.8
5.8 – 6.2
1.4 – 1.5
Specific gravity [g/ccm]
1.58 – 1.62
1.8 ± 0.1
1.50 – 1.55
Spreadability [at 23°C]
Min. 20 cm.
Min. 20 cm.
Min. 20 cm.
Tensile strength [MPa]
Min. 11.8
Min.11.8
Min. 11.8
Compression strength [MPa]
Min. 88.8
Min.88.8
Min.76.9
Abrasion Resistance [mm]
Max. 1.2
Max. 1.2
Max. 1.3
Hardness [Shore D scale]
Min. 80 ± 0.5
Min. 80 ± 0.5
Min. 80 ± 0.5
Adhesion with concrete [kG/sqcm]
Min. 35
Min.35
Min.32

For more accurate technical information as well as data concerning application details, please contact our technical staff.

For typical smooth, joint-less floor appearance, see pictures below:

5fi 2

5fi3

5fi4

5fi5

Image53

5fi7